# T-Modem-s1224 operator INI example
# Load via CDC: SET … / SAVE  (or flash defaults in firmware/s1224/config/default.ini)
#   SET device_id=s1224
#   SAVE
# SAVE persists a config blob in the last 4 KiB of Pico flash — not a filesystem.
# Boot banner is fixed in firmware source (always on CDC) — not an INI key.

[display]
starting=s1224 is starting
ready=s1224 is ready
fault=s1224 is fault
sending=s1224 is sending
signal=s1224 signal
packet=s1224 packet
power=s1224 power
idle=s1224 idle

[terminal]
callsign=
device_id=s1224
quiet=1

[sense]
cdt_active_high=0
packet_hold_ms=500
packet_edge_min=4
packet_window_ms=50